HOLDER FOR 2 AA CELLS, W/ SNAPS | All Electronics Corp

HOLDER FOR 2 AA CELLS, W/ SNAPS

Larger Picture Available

Unbreakable plastic holder for two AA batteries. Connection via 9V battery snaps. 2.43" x 0.90" x 0.65"
CAT# BH-321

Your Price: $0.75 each

Special Quantity Discounts!

10 to 99 $ 0.65 each

100 or more $ 0.50 each

In stock, ships within 24-48 hours.

Click here to email a friend about this item

Customer Comments
Write an online review of this part and share your thoughts with other viewers!

Avg. Customer Review: 4 out of 5 stars
Number of Reviews: 1

4 out of 5 stars Another "Fake Burgular Alarm" Project... 07/03/2007

Reviewer: KD7KNC from Kaysville, UT USA

I prev. gave some instructions using half-dead AA cells in a 6- AA cell series clip w/9V snaps. This one is easier, but needs NEW 1.5 V Alkaline AA cells (to make the nominal voltage required for the LED-4 (A/E-45cents)..... Take a 9V snap, peel off the insulation cover and wires, snap it on the loaded holder; try the leads of the LED, rotate as necess. until you find the position that it flashes. solder in this position. Stand upright in front and back windows of house. Current draw is so small it will flash for many months on a set of alkaline cells. It looks like an "armed" intrusion alarm to a would-be burgular. It costs little to build and run, and may discourage a break-in!

Was this review helpful to you?