ARDUINO PROTOSHIELD KIT

CAT# APS-14
$9.95 each
10 or more $8.95 each
Quantity:  
 
The ProtoShield mates with the Arduino USB board and gives the user a small soldering area, two general LEDs, access to a BlueSMiRF socket, a general pushbutton switch, and most important of all - the Arduino reset switch is brought to the top level.

This comes in kit form and must be soldered together by the end user. All soldering is through-hole (relatively easy) but always check your component orientation before soldering!

Kit Includes:
· 1x ProtoShield bare PCB
· 2x Stackable Headers 6-pin
· 2x Stackable Headers 8-pin
· 2x 5mm Basic Yellow LEDs
· 2x 330 Ohm resistors
· 1x 10k resistor
· 2x Momentary push buttons
· 2x 0.1uF Ceramic Capacitors

Features:
· All Arduino pins are brought to the top level
· 5V, GND, and Vin pins are exposed as well
· BlueSMiRF socket for wireless communication between Arduinos
· 2 general use LEDs
· 1 general use button
· Reset button brought to top level
Spec sheet available in PDF format.
There haven't been any reviews for this item, you may be the first one to write a review.

Customer Comments

There haven't been any reviews for this item, you may be the first one to write a review.