12VDC RIGHT-ANGLE GEAR HEAD MOTOR WITH WORM DRIVE

CAT# DCM-563

Web Only!
$17.95 each
14 Available
Quantity:  
 
No-load rating: 180 RPM @ 12Vdc / 1.3A. Overall length, 144mm (5.66"). Motor diameter, 49mm (1.91"). 12mm diameter worm shaft is 89mm (3.55") long. The last 12mm of the shaft has a 6 x 1.0 reverse metric thread. Heavy gauge U-bracket on back of gearhead, 1/4" holes with 7mm spacing. 3/16" quick-connect terminals. Designed for power seat adjustment in automobiles. Also available with worm gear in opposite direction, CAT# DCM-697.
Average Customer Review:  (3 Reviews) Write A Review

Customer Comments

Average Customer Review:  (3 Reviews) Write A Review

A customer from WORTHINGTON SPRINGS, FL USA
hardware
check out this link for hardware for this motorl
http://www.mcmaster.com/#acme-threaded-nuts/=dtic7b

A customer from NEWBURY, OH USA
Nuts!
A 1/2"-8 ACME nut works on this worm screw. It's a little sloppy because the diameter is under sized. It's definitely not a M12 x 3mm metric nut.

A customer from NORRISTOWN, PA USA
7/16 - 8 Thread
Very difficult to find, a company in Germany has a nut for this (www.pollin.de), but the price is prohibitive. I'm thinking about going the route of Moglice moulding putty, as suggested in another customer comment.