CAT# PM-376
$3.50 each
2.4" square panel meter. Full scale = 1mA DC. Imprinted with 0 - 15 and 0 - 3 VOLTS scales in black with white background. 1.1" long behind mounting plane. Four mounting studs on 1.875" centers. Solder-lug terminals.
Average Customer Review:  (1 Review) Write A Review

Customer Comments

Average Customer Review:  (1 Review) Write A Review

A customer from COLTON, SD USA
Good quality!
This meter simplifies assembly for a low-cost power supply, or entry level battery monitor. The volt scale is accurate with a 15K resistor. For the ammeter shunt (3 amp=.0185ohm) I used scrap stainless 16 gauge weld rod, ~45mm long. The stainless rod inside a spent windshield wiper blade was fine too. Of course, the scale can make 0-30volts, or 30ma or 150ma or...? Use a good DPDT switch to flip between Volts and Amps, meter at center poles.