This is a motor shield for Arduino that will control two DC motors. Based on the L298 H-bridge, the Ardumoto can drive up to 2 amps per channel. The board takes its power from the same Vin line as the Arduino board. Compatible with 3.3 and 5V logic. Includes blue and yellow LEDs to indicate active direction, and all driver lines are diode protected from back EMF.
Control for motor attached to OUT1/2 is connected to digital line 12 (direction A) and digital line 3 (PWM A).
Control for motor attached to OUT3/4 is connected to digital line 13 (direction B) and digital line 11 (PWM B).
Spec sheet available in PDF format.
There haven't been any reviews for this item,
you may be the first one to
write a review.
Customer Comments
There haven't been any reviews for this item, you may be the first one to
write a review.
Add to Wishlist
Tell a Friend
Customer Service: