2-PIN CONNECTOR W/HEADER, .10"

This combination prewired/crimp terminated header and connector are very convenient as I didn't have to mess with crimping the contacts or finding matching connector pairs.

Note that connectors are very similar, but slightly different than the Molex KK series .1" vertical locking headers and receptacles I've used on several designs.

(These receptacles did not fit exactly on the Molex header-had to replace the Molex with the matching one from this pair).

I use these connectors for the motor connection to the speed control when using GWS brushed EPS100C or EPS350C geared motors. Matches the GWS 2pin motor connector ..

I already had a 2 pin layout on my PCB for
power, but searched for ever looking for a prewired wire and plug to the battery holder
in the PacTek box I was using (no wires).
This worked out fine

I use these quite a lot (I ordered over 30 so far). When you solder wires to the male plug leave it in the female end. The plastic can melt slightly or get soft for a few moments and the pins will move around if not secured in the female end. A fast soldering job is needed for these.

The connector is pretty secure, normal vibration will not cause it to disconnect.

The pin spacing is correct, but the 1/2" long female plug is almost twice as long as the original. It protrudes into the battery compartment and the battery pack will no longer "seat" properly.