SOLDERABLE PERF BOARD, 3 HOLE PAD

These are great boards for prototyping and general-purpose project building. The holes are on a standard 0.10" grid, clustered in sets of three as shown, with staggered holes for connecting wires on one edge. There are bus lines running down either side of the board, with a row of single holes opposite the staggered holes on the other short edge. With tenth-inch spacing, they will accept standard ICs without any problem, and the three-hole clustering makes it easy to wire up circuits without having to break traces everywhere like you do with stripboard. I'm finally reaching the end of my original purchase of these, and am about to order another stack of them for more projects.

Is the spacing , between the (3 hole) pads, large enough for dip ic's/ sockets?? KD5BIH

These are great, maybe too great: if you are only using a piece of it, break it off before you build, as this is _very_ sturdy fiberglass.