S.P.S.T. miniature momentary pushbutton switch. Push-on, release-off. Press-fit in 0.31" diameter chassis hole. 0.39" diameter black bezel. Green button extends 0.29" above mounting plane in off-position. Switch body is 0.31" diameter x 0.5" long (excluding pc pins) below mounting plane.
Customer Comments
Patrick Schindler from LIVERMORE, CA USA
Good Value
I solder these on the end of a 0.156 pigtail (CAT# CON-232) to be used as a reset button. Legs are a little thin so before I heat the shrink wrap I back fill with hot glue. I am looking for the falling edge so bounce is of no concern (I have not looked at it on the scope).
A customer from Saint Paul, MN USA
Noisy
I bought this for use in some test projects (turning on LEDs, etc.), but when I tried putting it on an circuit that generates tones, I found the switch to be very noisy, causing a click in the output audio.
So as long as it's not being used in an audio circuit, should be fine.
A customer from tucson,az
attractive and good quality
i find these buttons very attractive - are very sturdy and are easily cleaned with spray air. the price is right
0 items, $0.00 
Add to Wishlist
Tell a Friend
Customer Service: