24 VDC GEAR MOTOR W/ TURNTABLE

CAT# DCM-351
$9.75 each
Quantity:  
 
Relatively powerful, low-current DC motor and gearbox with a 4.9" diameter plastic (nylon?) turntable with a rubber o-ring circumference that could be used to drive another wheel. Turntable can be removed from motor and rubber ring on turntable can be removed as well. Motor gearbox has a 5/16" diameter shaft that is flatted and splined.

Specifications:
45RPM @ 24 Vdc, 60mA - operates at 12Vdc at 1/2 speed. Drive motor - Mabuchi RS-380SH. 1.1" diameter x 1.67". Gearbox - Molon #CHM-2435-1. 2.75" x 3.00" x 0.57" Threaded mounting holes in four corners. 5/16" diameter shaft, flatted and splined.
Average Customer Review:  (8 Reviews) Write A Review

Customer Comments

Average Customer Review:  (8 Reviews) Write A Review

A customer from DUBLIN, CA USA
nice gearmotor
A good value for a gearmotor. Gearbox is slightly noisy on both units I got. Minimum speed is about 2 RPM at 2.3 V, 40 mA unloaded. Rubber O-Ring on turntable edge makes the package a nice robot wheel + motor. ID of 4 tapped holes on gearbox is 0.163", centers are 2.500" x 2.380" apart.

A customer from BOWIE, MD USA
Good.
Nice and slow. I found that "rack screws" fit the mounting holes.

A customer from PALMYRA, IN USA
Good buy on a geared DC motor.
One way bearing and sprocket - CAT# CH-10 fits nicely on this motors output shaft after smoothing the ridges. The turntable removes easily. Motor runs smoothly in both directions but a tad noisy. Great geared motor for the price!.

A customer from Murrieta, CA USA
AWESOME
this is small in size but works GREAT. It does have make a little noise but not worth a hassle. we use it a a Pachinko ball lifter

A customer from PELHAM, AL USA
Gearbox ratio
Fwiw, the gearbox ratio is 33:1. Also, I ordered two. One "turntable" was slightly warped, creating a minor wobble. But not enough to warrant replacement.