Hammond Manufacturing 1598BSGY. Gray ABS plastic. Two piece tongue and groove construction. 0.064" brushed aluminum front and rear panels. Integral pc standoffs. Front and rear vertical pc board guides. 5.26" x 5.3" x 2".
Drawing can be found here:
http://www.hammondmfg.com/pdf/1598B.pdf
comes with adhesive rubber feet.
Minor nicks and dings. A great project box.
2 of 2 people found this review helpful.
Do you?YesNoCertified buyer
Nice chassis case.
Reviewer: Jeff
from PA
I used this case to make PSK31 interface. It makes a nice equipment case to the ham shack. AA3JM (See pics on qrz.com)
1 of 1 people found this review helpful.
Do you?YesNo
Your picture is NOT worth a 1000 words!
Reviewer: A viewer
from Houston, TX USA
Your picture is not worth a 1000 words!
Actual box is MUCH better!!Very professional...
I think, the plastic wrap, causes a dull picture... I needed a box to mount my new 3" speaker (SK-482) and a two transistor amp in it.
This is a homebrew project. To amplify a low audio signal from a breadboard via a 1/8" jack. This will work nicely... KD5BIH
1 of 1 people found this review helpful.
Do you?YesNoCertified buyer
Nice project box
Reviewer: A viewer
from Lima, OH
Bought this for an enclosure for a controller to a remote antenna switch project. Very nice and price is reasonable. Will buy again if need arises.
Did you find this review useful?YesNoCertified buyer