ATMEGA328 WITH USB PORT

CAT# ARD-20
$8.95 each
This product is currently on Back Order and should be available after 06/20/18
 
Nano V3.0 ATmega328P Microcontroller Board w/ on-board USB port and headers. Bootloader installed, ready to upload sketches from Arduino software.

· Operating Voltage : 5V
· Input Voltage (recommended) 7V-12V
· Clock Speed 16 MHz
· Digital I/O Pins 14 (of which 6 provide PWM output)
· Analog Input Pins 8
· DC Current per I/O Pin 40 mA
· DC Current for 3.3V Pin 50 mA
· Flash Memory 32 KB (ATmega328) of which 2 KB used by bootloader
· SRAM 2 KB
· EEPROM 1 KB
· 45 x 17 x 19mm
Average Customer Review:  (1 Review) Write A Review

Customer Comments

Average Customer Review:  (1 Review) Write A Review

A customer from near Philadelphia, PA
Nano board
This is a reasonable price for a Nano clone. Nanos are easier to use than Pro Minis because they have a built-in USB interface. Almost all UNO sketches should work on Nanos with no changes at all. Headers are included so you can use them with any breadboard. You will need a USB A-mini B cable. a good deal!