Category Index


CAT # BH-31 (8 Reviews) Write a Review

$ 0.75
$0.75 each
10 + $0.65 each
100 + $0.50 each
+ Add to Wishlist
Product Description
Holder for single AA size battery. 2.25" long x 0.62" x 0.52" high. Unbreakable black plastic. Solder tabs.
WARNING: May cause cancer or reproductive harm.
California Prop. 65
Why is this here?
Customer Reviews (8 Reviews)

Write a Review (requires login)

Only a small flaw

Reviewer: from Minnesota

I couldn't get continuity with the battery until I trimmed back a plastic protrusion near the positive contact. The protrusion was intended to prevent continuity if the battery was installed backwards. It was a simple matter to trim it back with a knife.

I had no trouble soldering. Bend the tab out, and keep the iron at the tip of the tab, and use small wire.

1 of 2 people found this review helpful. Do you? Yes No

Hard to Mount, Melts Easily w/out leads

Reviewer: from Los Angeles, CA

Not only does this battery holder melt easily (almost immediately when soldering leads to it), it is also hard to mount. Comes with two small holes to screw screws through, but even with flat head screws, it seems to be in the way of the battery, thus pushing it out and not holding it properly.

1 of 1 people found this review helpful. Do you? Yes No

AA battery holder

Reviewer: from Franklinton, Nc USA

I used 4 of these and i only had a problem with one of the 4 melting the only problem that i saw with them is the posotive side melting easy. I love these battery holders tho they work great.

Did you find this review useful? Yes No

Faster soldering technique

Reviewer: from USA

To solder faster, apply a small amount of liquid flux to wire and tab. Attach wire to tab, apply a small amount of solder to iron and with solder ready, touch iron to tab instantly applying solder to tab also. I have had this melting problem on ckt. brds and this is a useful technique. Good Luck.

Did you find this review useful? Yes No

Very easy to melt, poor connectivity

Reviewer: from WHITEHALL, MI US

I was using this holder while breadboarding some LED circuits (connected with alligator clips)and after a short while found that it had a fault in the rivet to the negative terminal. Knowing full well from other reviews how sensitive this is to heat, I carefully attempted to solder a thin wire to the terminal. The surrounding plastic melted almost immediately. I would reccomend you find another battery clip to use, this one is worthless.

Did you find this review useful? Yes No
Next Page

You might also like