Category Index

6 VDC, 25 RPM GEAR MOTOR

CAT # DCM-470 (2 Reviews) Write a Review

Clearance Large Quantity
$ 4.25
$4.25 each
10 + $4.00 each
100 + $3.75 each
Quantity:
+
4151 Available
+ Add to Wishlist
Product Description
Gear head motor with an arm that rotates an offset axle in a 1" circle. Includes a slotted link rod that can be used to facilitate reciprocating action.

• Motor dimensions: 1.45"D x 3.00"L
• No-load specs: 25RPM @ 6Vdc, 150mA
• Crank with offset axle rotates in a 1" circle
• Crank can be unscrewed, leaving a 10-32 stub shaft
• Includes a metal mounting bracket and slotted link rod
• Prepped with wire leads

To unscrew crank from shaft:
•Remove metal bracket.
•Grasp crank with pliers and yank quicky in counter-clockwise direction.
•May need to apply heat to break Loctite® bond.
WARNING: May cause cancer or reproductive harm.
California Prop. 65
Why is this here?
Customer Reviews (2 Reviews)

Write a Review (requires login)

Crank removal

Reviewer: from Tucson AZ, USA

The crank unscrews revealing a 10-32 stub shaft. Fine motor

23 of 23 people found this review helpful. Do you? Yes No

High Quality, Starts and Runs on 3V

Reviewer: from Big C Possum Ranch and Technology Park, Belchertown, MA

Got these to replace a wood furnace draft damper actuator. These are very high quality, heavy gauge brackets. They come with some extra bushings that fit inside the slot and also fit the axle arm pin so there are many ways this can be adapted to motion. It starts and runs nicely - strong and quiet - on 3vdc so I can use it with a 3V controller system and single LiPo cell backup. The current drawn is 200mA at 6V and exactly the same at 3V.

4 of 4 people found this review helpful. Do you? Yes No  Certified buyer


You might also like