12 VDC AUTOMOBILE DOOR LOCK ACTUATOR

CAT # DLA-1 5 out of 5 stars(47 Reviews) Write a Review

$ 5.50
$5.50 each
Quantity:
+
+ Add to Wishlist
Product Description
• 12 Vdc motor-drive actuator for automotive door locks
• Push or pull 0.75" depending on polarity
• Overall dimensions (retracted): 5.50" x 2.45" x 1.25"
• Nylon plunger
• Mounting hardware includes 9.5" metal linkage rod
• Rubber boot protects against moisture and dust
• Pigtail leads
WARNING: May cause cancer or reproductive harm.
California Prop. 65
Why is this here?
Customer Reviews 5 out of 5 stars(47 Reviews)

Write a Review (requires login)

Great deal 5 out of 5 stars

Reviewer: from TEHACHAPI, CA US

I bought this actuator to replace the rear hatch actuator for my 2001 Ford Escape rear hatch/glass door. Ford dealer wanted over $200 because you have to buy the whole interior assembly. If they replace it, another $100+. I had to drill one hole, hook up the wires--green to striped, and find a lock nut and screw to fit the plunger end.
This may not be the highest quality device and does get warm if voltage is applied longer than necessary. It probably does not have brushes as someone stated--probably permanent magnet, but still can be burnt up if overused.
I'm real happy--good price--fast shipping--working great.

125 of 226 people found this review helpful. Do you? Yes No

Rear Door Actuator 5 out of 5 stars

Reviewer: from DENVER, CO US

The rear hatch lock actuator stopped working on my 2001 Ford Escape ( same problem as the previous reviewer stated )... took apart old assembly.... Drilled 1 hole for new actuator..... used old top assembly and put on new part...put back together and 2 minutes worth for wiring.... wala.... 30 minute job.... thx

89 of 177 people found this review helpful. Do you? Yes No

1999 F250 Super Duty Actuator Replacement 5 out of 5 stars

Reviewer: from SHALLOWATER, TX US

These parts absolutely rock. They worked fantastically well as aftermarket fixes for my 1999 F250 Super Duty actuators. Although I didn't *replace* the failed actuators with this, I did simply install these and tie them inline with the existing rods and it worked like a charm. These parts are a fraction of the cost of the Ford replacement part, and quite frankly removing the failed part and reinstalling on my Super Duty would be a real pain in the posterior. It's quite a chore to get the Ford parts out as they are attached to the door latch. Just use these after market parts and tie into the existing rods and you'll have a terrific solution, very powerful actuators and have saved literally $100 on parts (four doors).

I cannot say how pleased I am with the parts, the price, the prompt delivery. You have a return customer when my needs turn to the type of parts you supply.

48 of 98 people found this review helpful. Do you? Yes No

Loads of fun! 5 out of 5 stars

Reviewer: from Portland, OR

I once found one of these laying around. I hooked up four rectifiers, a capacitor and a flashlight bulb to make a little emergency flashlight.

Never knew its real purpose until now!

3 of 8 people found this review helpful. Do you? Yes No

actuator works great A+++++ 5 out of 5 stars

Reviewer: from SHREVEPORT LA

I OWN A 2000 FORD F-150 AND THE FACTORY ACTUATORS ARE VERY EXPENSIVE I CLIPPED THE FACTORY AND INSTALLED THESE AND THEY WORK GREAT DURING THIS DAY AND TIME OF DEPRESSION I SAY THANK YOU !!!

5 of 6 people found this review helpful. Do you? Yes No
Next Page


You might also like