Category Index

VEHICLE SENSOR/ CONTROL? FFM-150A

CAT # FFM-150A 2 out of 5 stars(1 Review) Write a Review

$ 0.50
2 for $1.00
2 pieces minimum order
Quantity:
+
+ Add to Wishlist
Product Description
DeAmertek Corporation P/N FFM-150A.
Looking for help here! Let us know if you know what they are. We've got quite a few of these "Black-box" sensors or controls, probably for a motor vehicle. Black epoxy block, 2.0" x 0.80" x 0.50", five pigtail leads.
WARNING: May cause cancer or reproductive harm.
California Prop. 65
Why is this here?
Customer Reviews 2 out of 5 stars(1 Review)

Write a Review (requires login)

It's an h-bridge circuit with driver; running at 192 Hz 2 out of 5 stars

Reviewer: from San Jose, CA

Contains two-transistor multivibrator running at ~192 Hz. This drives an H-Bridge of 4 transistors (NPN silicon bipolar parts). Power to the H-Bridge is through the center (blue) wire. Voltage to multivibrator is through the red wire.

Making the following connections will power up the unit, wire colors below are in order as they exit one side of the device. Voltages are just some sample values that worked to power up the device.
white: connect to ground
white: output of one leg of h-bridge
blue: power to h-bridge transistors (+12V)
blue: output of other arm of h-bridge
red: power to multivibrator circuit that drives the h-bridge (+12V)

With no load connected to h-bridge, current through red wire is ~6.5 mA

All parts mounted on ceramic circuit board, thick film resistors (embedded) and discreet capacitors. Easy to take apart. Board is encapsulated in soft rubber compound. It is well made, but what to use it for?

3 of 3 people found this review helpful. Do you? Yes No  Certified buyer


You might also like