Category Index


CAT # FHBL-80 3 out of 5 stars(1 Review) Write a Review

$ 11.55
$11.55 each
+ Add to Wishlist
Product Description
8-circuit fuse block for ATO/ATC blade fuses. Clear cover with gasket protects fuses from dust and water. Bulkhead mount. 1.43" high with cover. 1.75" wide with terminals. 4.71" overall length, including mounting tabs. 1/4" QC/ solder terminals.
WARNING: May cause cancer or reproductive harm.
California Prop. 65
Why is this here?
Customer Reviews 3 out of 5 stars(1 Review)

Write a Review (requires login)

Hopefully it will hold up 3 out of 5 stars

Reviewer: from NH

The 1/4" tabs are not solid. Made of thin metal and folded over to create a 1/4" tab. I wanted to make one side a buss bar so started drilling to enlarge the hole to run a bare copper wire through. The folded metal ripped to pieces on some tabs, one sheared off. Using some proper width tie wraps (what I had on hand) and was able to depress the keepers and push the contacts out of the holder and drill them while clamping the folded 1/4" blade nearby with a pair of pliers. Re-assembled pushed my bare copper 12g solid wire through the enlarged holes. Put the sheared off one on the end and salvaged it by placing a 90 degree bend in wire and soldering it and the remaining 7 tabs. Now one side is all common for the 12Vdc buss.

The clear cover is difficult to attach, first align the alignment bung on cover with holder, then roll the cover on starting with the long side nearest to the alignment bungs. Just wouldn't go on by pushing straight down, had to 'roll' it on. Otherwise only one side would latch.

3 of 4 people found this review helpful. Do you? Yes No  Certified buyer

You might also like